Tile Floor Installation in Lynnwood WA - Flat, Tight and Built to Last

Tile is a smart pick in rooms that get wet or see heavy foot traffic. Kitchens, bathrooms, laundry rooms, and entryways are the usual ones. Rain gets tracked in all fall and winter around here, and tile shrugs it off.

So how do you know it is time? Start with cracks. A single cracked tile might be a dropped pan. A line of cracks running across several tiles means the floor underneath is moving. Replacing tiles will not hold until that is fixed.

Tap on the tile with a coin. A hollow sound means the tile has come loose from its bed. Grout that crumbles or turns dark is another warning. Grout is the filler between tiles. When it fails, water gets under the floor.

That is the bigger worry in this climate. Water under a bathroom floor feeds mold and rot in the wood below. In older Lynnwood and Edmonds homes, we often find soft subfloors under tile that looked fine on top. If your bathroom floor gives a little when you step, call us soon.

A remodel is the other big reason. Maybe you are pulling out a worn vinyl floor, finishing a basement, or opening up a kitchen. New tile gives you a clean start.

Basements need extra thought. Moisture rising through the slab can lift tile over time. We check for it before we set anything.

If you are not sure what you are looking at, send us a photo or call. We can usually look at your project quickly.

Good tile work is mostly what you never see. The base decides everything.

We start with a free estimate. No trip fee. We measure the room, look at the old floor, and check how level it is. We also ask what tile you have in mind. Size, material, and pattern all change how we work. Large tiles need a flatter base than small ones.

You then get an itemized quote in writing. It covers tile setting, materials, prep, and removal of the old floor.

On work day, we protect your home and tear out whatever is there. Old tile comes up with chisels and breakers. It is noisy and dusty, and we contain it as best we can. Once it is bare, we check the subfloor for rot, soft spots, and movement.

Repairs come before tile. Bad wood gets cut out and replaced. Low spots are filled. In wet rooms, we add a waterproof layer so moisture cannot reach the wood. Over a slab, we may use a crack isolation membrane, a thin sheet that keeps a small slab crack from reaching your tile.

Next is layout. We snap lines and dry-fit the tiles before any glue goes down. This keeps cuts balanced at the walls and keeps lines straight through doorways. Then we spread thinset, a strong cement-based glue, with a notched trowel and press each tile in. We use spacers to hold even joints.

The tile needs time to set before grout goes in. Then we grout, wipe it clean, and seal it where needed. Curing takes a day or more, so you stay off the floor until we say it is ready.

Permits are not usually needed for tile alone. If your job includes structural repair or plumbing changes, we handle permits in-house.

We finish with a walk-through and a full cleanup.

Two tile jobs of the same size can end up with very different prices. Here is why.

The tile itself is the first piece. Basic ceramic is easy to find and easy to cut. Porcelain is harder and takes more effort. Natural stone is heavier and needs more care. Large format tiles and tiny mosaics both take extra time to set right.

Then comes the pattern. Straight rows go fast. Diagonals, herringbone, and mixed sizes mean more cuts and more waste.

Prep is where surprises hide. Taking out old tile glued to a slab is heavy work. Fixing a rotted subfloor adds repair time and materials. A floor that is not level needs patching before we can start.

The room matters as well. Bathrooms have tubs, toilets, and vanities to work around. Kitchens have cabinets. Tight spaces slow us down. If fixtures have to come off and go back on, that is part of the job too.

Finally, extras like waterproofing layers, heated floor wiring, and new trim add to the total.

Here is what you can count on. The estimate is free, with no trip fee. The quote is honest and itemized, so you see each line. There are no hidden fees. If we open the floor and find rot, we show you, explain it, and agree on next steps before the price moves.

We would rather lose a job than surprise you with a bill.

JE Remodeling Solutions is family-owned and based in Lynnwood. John Eric Fernandez learned the trade from his father. That is more than 25 years of hands-on experience, and it shows in how flat and tight the floors come out.

We are a licensed Washington State general contractor. We are bonded and insured, so you are covered. We are a full general contractor. That means we can also fix the framing or subfloor under your tile, so you do not need a second crew.

You get one point of contact. We reply fast, about 30 minutes on average. We are open Monday to Saturday, 9 to 5.

We work in Lynnwood, Bothell, Seattle, Edmonds, Mountlake Terrace, Shoreline, Kenmore, Lake Forest Park, Woodinville, Kirkland, and Everett. We have worked on plenty of older homes, so we can spot what tends to hide under the floor.

If something is not right, we make it right. That is our workmanship guarantee. We also clean up thoroughly and dispose of all debris.